Hikvision Microphone Wiring Diagram394

Proper microphone wiring is crucial for ensuring clear and effective audio surveillance. This article provides a comprehensive guide to the wiring connections for Hikvision microphones, ensuring optimal performance and reliable operation.

Types of Hikvision MicrophonesHikvision offers a diverse range of microphones, including:
* Analog Microphones: Transmit audio signals via analog cables.
* IP Microphones: Transmit audio signals over Ethernet networks.
* PoE Microphones: Receive power and transmit audio signals over Ethernet cables.

Wiring RequirementsThe specific wiring requirements for Hikvision microphones vary depending on the type of microphone and the desired connection method.

Analog Microphones

* Shielded Twisted Pair (STP) Cable: Category 5 or higher twisted pair cable with shielding.
* BNC Connectors: Male BNC connectors for the microphone end and female BNC connectors for the DVR input.

IP Microphones

* Ethernet Cable: Category 5e or higher Ethernet cable.
* RJ45 Connectors: Male RJ45 connectors for both the microphone and the network device.

PoE Microphones

* Shielded Twisted Pair (STP) Cable: Category 5e or higher twisted pair cable with shielding.
* RJ45 Connectors: Male RJ45 connectors for both the microphone and the PoE injector.

Color CodingThe color coding for Hikvision microphone wiring is as follows:
* Positive (+): Red
* Negative (-): Black
* Ground (G): Green

Wiring Diagrams

Analog Microphone Wiring
![Analog Microphone Wiring Diagram]()
1. Connect the red wire from the microphone to the red (positive) terminal on the BNC connector.
2. Connect the black wire from the microphone to the black (negative) terminal on the BNC connector.
3. Connect the green wire from the microphone to the green (ground) terminal on the BNC connector.


IP Microphone Wiring
![IP Microphone Wiring Diagram]()
1. Connect the RJ45 connector from the microphone to a PoE switch or injector.
2. Connect the RJ45 connector from the PoE switch or injector to the network.


PoE Microphone Wiring
![PoE Microphone Wiring Diagram]()
1. Connect the red wire from the microphone to the red (positive) terminal on the RJ45 connector.
2. Connect the black wire from the microphone to the black (negative) terminal on the RJ45 connector.
3. Connect the green wire from the microphone to the green (ground) terminal on the RJ45 connector.
4. Connect the RJ45 connector from the microphone to a PoE injector.
5. Connect the PoE injector to the network.

TroubleshootingIf you encounter any issues with your Hikvision microphone wiring, follow these troubleshooting steps:
* Check that the wiring connections are secure and have no shorts or breaks.
* Ensure that the color coding is correct.
* Verify that the microphone is compatible with the recording device.
* If using an IP microphone, test the network connection and ensure that the microphone has a valid IP address.

ConclusionBy following the wiring instructions outlined in this article, you can ensure that your Hikvision microphones are properly connected for optimal audio performance. With clear and reliable audio, you can enhance the effectiveness of your surveillance system and gain valuable insights from audio monitoring.

2024-10-23

---

Previous：A Comprehensive Guide to Dual Monitor Setups

Next：Hikvision Surveillance Network Configuration Guide