Huawei Wired Surveillance Configuration Guide370

Introduction

This guide provides step-by-step instructions for configuring Huawei wired surveillance devices, including IP cameras, switches, and NVRs (Network Video Recorders). By following these instructions, you can effectively set up and manage your wired surveillance system.

IP Camera Configuration

Step 1: Connect the IP Camera

Connect the IP camera to your network using an Ethernet cable. Power on the camera and wait for it to boot up.

Step 2: Access the IP Camera Web Interface

Open a web browser and enter the IP address of the IP camera into the address bar. The default IP address is usually printed on the camera's label.

Step 3: Configure Camera Settings

- Set the camera's name and description.

- Configure the camera's video resolution, frame rate, and bitrate.

- Adjust the camera's image settings, such as brightness, contrast, and white balance.

Switch Configuration

Step 1: Connect the Switch to the Network

Connect the switch to your network using Ethernet cables. Power on the switch and wait for it to boot up.

Step 2: Access the Switch Web Interface

Open a web browser and enter the IP address of the switch into the address bar. The default IP address is usually printed on the switch's label.

Step 3: Configure Switch Settings

- Set the switch's name and description.

- Configure the VLAN (Virtual LAN) for the surveillance traffic.

- Enable PoE (Power over Ethernet) for the ports connected to IP cameras.

NVR Configuration

Step 1: Connect the NVR to the Network

Connect the NVR to your network using an Ethernet cable. Power on the NVR and wait for it to boot up.

Step 2: Access the NVR Web Interface

Open a web browser and enter the IP address of the NVR into the address bar. The default IP address is usually printed on the NVR's label.

Step 3: Configure NVR Settings

- Set the NVR's name and description.

- Add the IP cameras to the NVR.

- Configure the recording settings, such as resolution, frame rate, and storage allocation.

System Configuration

Step 1: Connect the Devices

Connect the IP cameras, switch, and NVR together using Ethernet cables.

Step 2: Set Up the VLAN

Create a VLAN on the switch for the surveillance traffic. Assign the IP cameras and NVR to the VLAN.

Step 3: Configure the Cameras in the NVR

Open the NVR web interface and add the IP cameras to the NVR. Configure the recording settings for each camera.

Step 4: Verify the System

Access the NVR web interface and verify that the cameras are streaming video and that the NVR is recording it.

Conclusion

By following these instructions, you have successfully configured your Huawei wired surveillance system. You can now monitor and record video footage from your IP cameras, providing you with enhanced security and surveillance capabilities.

2025-02-07

Previous：Miniature Security Camera Installation Guide

Next：How to Configure Monitoring Equipment for Optimal Performance