Tesla Pedal Monitoring System Installation Guide128

Introduction

The Tesla Pedal Monitoring System is a safety feature that helps to prevent unintended acceleration. It does this by monitoring the position of the accelerator and brake pedals, and if it detects that the accelerator is being pressed while the brake is not, it will reduce the power to the motor. This can help to prevent accidents caused by pedal misapplication.

Tools and Materials

To install the Tesla Pedal Monitoring System, you will need the following tools and materials:
Tesla Pedal Monitoring System kit
10mm socket wrench
13mm socket wrench
Flathead screwdriver

Installation Instructions

1. Disconnect the negative terminal of the battery.

2. Remove the two bolts that hold the accelerator pedal in place, and then remove the pedal.

3. Install the Tesla Pedal Monitoring System sensor onto the accelerator pedal arm, and then tighten the bolts to secure it.

4. Route the sensor wire up the steering column, and then connect it to the Tesla Pedal Monitoring System module.

5. Install the Tesla Pedal Monitoring System module under the dashboard, and then secure it with the included screws.

6. Reconnect the negative terminal of the battery.

Testing the System

Once the Tesla Pedal Monitoring System is installed, you should test it to make sure that it is working properly. To do this, start the car and then press the accelerator pedal. The system should immediately reduce the power to the motor, and the brake lights should come on. If the system is not working properly, you should contact Tesla for assistance.

Additional Information

The Tesla Pedal Monitoring System is a valuable safety feature that can help to prevent unintended acceleration. It is important to install the system correctly and test it to make sure that it is working properly. If you have any questions about the installation or operation of the system, you should contact Tesla for assistance.

2025-02-02

Previous：Non-WiFi Security Camera Installation Guide

Next：Remote Monitoring IP Configuration