Driving Recorder Wiring Installation Guide141

A driving recorder, also known as a dash cam, is an essential device for capturing footage of your journey and providing evidence in the event of an accident. While some driving recorders come with built-in batteries, others require a wired connection to your vehicle's electrical system for continuous operation.

Installing a driving recorder wiring kit is not a difficult task, but it does require some basic electrical knowledge and tools. Here is a step-by-step guide to help you install the wiring kit for your driving recorder:

Step 1: Gather Your Materials

Before you begin, you will need to gather the following materials:
Driving recorder wiring kit
Phillips head screwdriver
Trim removal tool
Electrical tape
Wire strippers
Crimping tool
Voltmeter (optional)

Step 2: Determine the Fuse Box Location

The first step is to locate the fuse box in your vehicle. This is typically located under the dashboard on the driver's side. Consult your vehicle's owner's manual for the exact location.

Step 3: Identify a Suitable Fuse

Once you have located the fuse box, you need to identify a suitable fuse to connect the driving recorder wiring kit. Look for a fuse that is not essential for the operation of your vehicle, such as the radio or power windows. The fuse should also have a amperage rating that is compatible with the driving recorder (usually 10-15 amps).

Step 4: Remove the Fuse

Using the fuse puller provided in the fuse box, carefully remove the fuse.

Step 5: Connect the Fuse Tap

Take the fuse tap from the wiring kit and connect it to the fuse you removed in the previous step. The fuse tap should have two slots, one for the original fuse and one for the new fuse that will power the driving recorder.

Step 6: Insert the Fuse

Insert the original fuse into the bottom slot of the fuse tap and the new fuse into the top slot. The new fuse should have the same amperage rating as the original fuse.

Step 7: Route the Wiring

Route the driving recorder wiring harness from the fuse box to the desired location for the driving recorder. Use the trim removal tool to carefully pry apart the interior panels of your vehicle to conceal the wiring.

Step 8: Connect the Driving Recorder

Connect the power cable from the wiring kit to the driving recorder. The power cable typically has a red wire for positive and a black wire for negative.

Step 9: Test the Connection

Turn on the ignition of your vehicle to test the connection. The driving recorder should power on automatically. If it does not, check the wiring connections and make sure that the fuse is properly installed.

Step 10: Secure the Wiring

Use electrical tape or zip ties to secure the wiring in place and prevent it from becoming loose or tangled.

Troubleshooting

If you encounter any problems during the installation process, here are some troubleshooting tips:
The driving recorder does not power on: Check the wiring connections and make sure that the fuse is properly installed. You can also use a voltmeter to test the voltage at the fuse tap.
The driving recorder turns off when the vehicle is turned off: This may be because the wiring kit is not connected to a constant power source. Try connecting the wiring kit to a different fuse that is hot even when the ignition is off (such as the cigarette lighter).
The driving recorder is recording video but the footage is flickering: This may be due to a loose connection or a faulty power source. Check the wiring connections and make sure that the fuse is properly installed.

By following these steps, you can easily install a driving recorder wiring kit in your vehicle. This will ensure that your driving recorder is always powered and ready to capture footage in the event of an accident.

2025-01-31

Previous：Script Monitor Screen Setup

Next：Industrial Welding Machine Monitoring: A Comprehensive Video Tutorial