Mercury Monitoring Gateway Installation Guide82

Introduction
The Mercury Monitoring Gateway (MMG) is a vital component of the Mercury Monitoring System, enabling the transmission of data from remote monitoring devices to the Mercury Monitoring Platform (MMP). This guide will provide step-by-step instructions for the installation and configuration of the MMG.
Prerequisites
Before proceeding with the installation, ensure that you have the following:
* MMG device
* Ethernet cable
* Power adapter
* Access to the MMP
Installation
1. Connect the MMG to the Network:
- Connect the Ethernet cable from the MMG to an Ethernet port on your router or switch.
- Ensure the Ethernet port is connected to the internet.
2. Power on the MMG:
- Connect the power adapter to the MMG and plug it into a power outlet.
- The MMG will turn on and begin initializing.
Configuration
Once the MMG is powered on, you will need to configure it to connect to the MMP.
1. Access the Configuration Page:
- Open a web browser and enter the MMG's IP address in the address bar.
- The default IP address is typically 192.168.1.100.
- You may need to check the manufacturer's documentation for the exact IP address.
2. Configure the Network Settings:
- Navigate to the "Network" tab.
- Select the "Wired Connection" option.
- Configure the IP address, subnet mask, and default gateway settings according to your network configuration.
- If necessary, configure the DNS settings.
3. Connect to the MMP:
- Navigate to the "Mercury Monitoring" tab.
- Enter the MMP URL and the MMP API key.
- Click the "Connect" button.
- The MMG will attempt to connect to the MMP.
Monitoring Devices
1. Pairing Devices:
- To pair monitoring devices with the MMG, press the "Pair" button on the MMG.
- Within 60 seconds, activate the pairing mode on the monitoring device.
- The MMG will automatically detect and pair with the device.
2. View Monitoring Data:
- Once the devices are paired, they will begin transmitting data to the MMG.
- You can view the monitoring data in real-time through the MMP.
Maintenance
1. Firmware Updates:
- The MMG firmware may need occasional updates to maintain optimal performance.
- Check the manufacturer's website for any available firmware updates.
2. Troubleshooting:
- If the MMG is not functioning properly, check the following:
- Power adapter is securely connected.
- Ethernet cable is not damaged.
- Network settings are correct.
- MMP URL and API key are valid.

This article provides a comprehensive guide to installing and setting up the Mercury Monitoring Gateway (MMG), which plays a crucial role in connecting remote monitoring devices to the Mercury Monitoring Platform (MMP). It covers the necessary prerequisites, step-by-step installation instructions, configuration settings, device pairing, monitoring data viewing, and ongoing maintenance.

After installing and powering on the MMG, users can access the configuration page via its default IP address. Network settings, including IP address, subnet mask, and gateway, must be configured to match the network infrastructure. The MMG establishes a secure connection to the MMP using the provided URL and API key.

Pairing monitoring devices with the MMG is essential for data transmission. By activating pairing mode on both the MMG and monitoring devices, users can seamlessly connect them for real-time data transfer. The monitoring data is then accessible through the MMP.

Maintenance measures ensure optimal performance of the MMG. Firmware updates released by the manufacturer should be applied regularly. Troubleshooting potential issues, such as power connectivity, network settings, or MMP credentials, helps maintain proper functionality of the system.

By following the instructions outlined in this guide, users can successfully install, configure, and integrate the MMG, enabling efficient monitoring of remote devices and data transmission to the MMP.

2025-01-16

---

Previous：Monitor Channel Setup Naming

Next：Monitoring the Outdoor Network: A Comprehensive Guide