DIY Doorbell Camera Battery Replacement Guide86

A doorbell camera is a great way to keep an eye on your home, but the battery can die at the most inconvenient times. If you're not sure how to replace the battery in your doorbell camera, don't worry - this guide will walk you through the process step-by-step.

Tools You'll Need
New battery
Screwdriver
(Optional) Toothbrush or cotton swab

Step-by-Step Instructions

1. Remove the doorbell camera from the wall.

Most doorbell cameras are attached to the wall with a few screws. Use your screwdriver to remove the screws and carefully lift the camera off the wall.

2. Open the doorbell camera.

The back of the doorbell camera should have a small panel that can be opened. Use your screwdriver to remove the screws that hold the panel in place and then carefully lift the panel off.

3. Locate the battery.

The battery will be located inside the doorbell camera. It will typically be a small, rectangular battery that is connected to the camera with a few wires.

4. Disconnect the battery.

Use your screwdriver to disconnect the wires that are connected to the battery. Be careful not to damage the wires.

5. Remove the battery.

Once the battery is disconnected, you can remove it from the camera. Be careful not to drop the battery, as this could damage it.

6. Clean the battery terminals.

Over time, the battery terminals can become dirty or corroded. This can prevent the battery from making a good connection with the camera. Use a toothbrush or cotton swab to clean the terminals.