[How to Install a Hardwired Doorbell Camera]187

In this guide, you will learn how to install a hardwired doorbell camera. It is important to note that the installation process may vary depending on the specific model of doorbell camera you have. Please consult your product's user manual for specific instructions.

Before You Start

Before you begin the installation, gather the following tools and materials:
Drill
Screwdriver
Wire strippers
Electrical tape
Level
Caulk gun
Caulk

Step 1: Turn Off the Power

Before you begin working on the electrical wiring, turn off the power to your doorbell at the circuit breaker or fuse box.

Step 2: Remove the Old Doorbell

Use a screwdriver to remove the screws that hold the old doorbell in place. Disconnect the wires from the doorbell and remove it from the wall.

Step 3: Prepare the New Doorbell

Run the wires from the wall through the back of the new doorbell camera. Use the wire strippers to remove about 1/2 inch of insulation from the ends of the wires.

Step 4: Connect the Wires

Connect the wires to the corresponding terminals on the back of the doorbell camera. The positive wire will typically be red or black, and the negative wire will typically be white or green. Twist the wires together and secure them with electrical tape.

Step 5: Mount the Doorbell

Use the drill to create pilot holes for the screws that will hold the doorbell camera in place. Insert the screws and tighten them until the doorbell is secure.

Step 6: Level the Doorbell

Use a level to make sure that the doorbell camera is level. Adjust the screws as needed to level the doorbell.

Step 7: Caulk the Edges

Apply a bead of caulk around the edges of the doorbell to seal out moisture and prevent drafts.

Step 8: Restore Power

Restore power to your doorbell at the circuit breaker or fuse box.

Step 9: Test the Doorbell

Press the doorbell button to test the doorbell camera. The doorbell should chime and the camera should start recording.

Tips
If you are not comfortable working with electrical wiring, it is best to hire a qualified electrician to install the doorbell camera for you.
Make sure that the doorbell camera is installed in a location where it will have a clear view of the area you want to monitor.
Test the doorbell camera regularly to make sure that it is working properly.

2025-01-06

Previous：How to Set Up a Bridge for Monitoring Devices

Next：Monitoring and Detecting in Network Configuration