Titan Monitoring: Assembly Instructions322

Introduction

Thank you for choosing Titan Monitoring for your surveillance needs. Our products are designed to provide the highest level of security and efficiency. This assembly guide will provide you with step-by-step instructions for installing your Titan monitoring system.

Tools Required
Screwdriver
Drill
1/4-inch drill bit
Level
Measuring tape

Components Included
Camera
Mounting bracket
Power adapter
Network cable
Screws
Anchors

Step 1: Choose a Location

Select a location that provides a clear view of the area you want to monitor. The camera should be placed at a height of 8-10 feet above the ground. Ensure that the location has access to a power outlet and network connection.

Step 2: Mount the Camera

Use the mounting bracket to attach the camera to the chosen location. Use the drill to create pilot holes for the screws. Insert the anchors into the pilot holes and then screw the bracket into place. Level the camera using a spirit level.

Step 3: Connect the Power Adapter

Plug the power adapter into the camera and then into a power outlet. Ensure that the power outlet is switched on.

Step 4: Connect the Network Cable

Plug the network cable into the camera and then into a router or switch. Ensure that the network connection is active.

Step 5: Configure the Camera

Use a web browser to access the camera's configuration page. The default IP address for the camera is 192.168.1.100. The default username and password are both "admin."

Configure the camera's network settings, including the IP address, subnet mask, and default gateway. You can also adjust the camera's video settings, such as the resolution, frame rate, and white balance.

Step 6: Test the Camera

Once the camera is configured, test the camera to ensure it is working properly. Verify that the video feed is clear and without any interruptions. Adjust the camera's position and settings as necessary until you are satisfied with the results.

Troubleshooting

If you experience any issues during the assembly or configuration process, please consult the following troubleshooting tips:
Ensure that all connections are secure.
Reset the camera by pressing the reset button for 10 seconds.
Check the camera's user manual for specific troubleshooting steps.

Conclusion

Congratulations on assembling your Titan monitoring system. By following these instructions carefully, you can ensure that your system is installed and configured properly. If you have any further questions or need assistance, please do not hesitate to contact our support team.

2024-12-23

Previous：How to Setup Coaxial Security Cameras: A Comprehensive Guide

Next：Home Surveillance Camera Installation Guide