How to Factory Reset Sony Security Cameras108

Factory resetting your Sony security camera can be necessary for a variety of reasons. Maybe you're troubleshooting an issue, selling the camera, or just want to start from scratch. Whatever the reason, resetting your camera to its factory default settings is a relatively simple process.

Before You Begin

Before you begin the factory reset process, there are a few things you should do:
Make sure the camera is powered on.
Have a pen or paper handy to write down the camera's default IP address and password (if you don't know them).
Back up any important settings or recordings that you want to keep.

Factory Reset Methods

There are two ways to factory reset a Sony security camera:

Method 1: Using the Web Interface

Open a web browser and enter the camera's IP address in the address bar.
Log in to the camera using the default username and password (if you don't know them, check the camera's manual).
Navigate to the "Maintenance" or "Settings" tab.
Click on the "Factory Reset" button.
Confirm that you want to reset the camera to its factory default settings.

Method 2: Using the Reset Button

Locate the reset button on the camera. It is usually a small, recessed button.
Use a pen or paperclip to press and hold the reset button for about 10 seconds.
Release the reset button and wait for the camera to reboot.

After the Factory Reset

Once the factory reset is complete, the camera will restart and be restored to its default settings. You will need to reconfigure the camera before you can use it again.

Here are some of the things you will need to do after a factory reset:
Set a new IP address for the camera.
Create a new username and password for the camera.
Configure the camera's network settings.
Configure the camera's recording settings.
Restore any backed-up settings or recordings.

Troubleshooting

If you have any problems factory resetting your Sony security camera, try the following troubleshooting tips:
Make sure that the camera is powered on.
Make sure that you are using the correct IP address and password to log in to the camera.
Try resetting the camera using the reset button method.
Contact Sony support for help.

2024-11-06

---

Previous：Solar Monitoring System Installation Guide

Next：Home Network Storage Surveillance Setup