Hikvision Wired Surveillance Installation Manual304

Introduction

Thank you for choosing Hikvision wired surveillance products. This manual provides detailed instructions on how to install and configure your Hikvision wired surveillance system. Please read this manual carefully before beginning the installation process.

Materials Required

The following materials are required for the installation of a Hikvision wired surveillance system:
Hikvision wired surveillance cameras
Hikvision network video recorder (NVR)
Ethernet cables
Power cables
Mounting brackets
Tools (e.g., drill, screwdriver, wrench)

Camera Installation

1. Determine the location where you want to install the camera.
2. Mark the mounting holes on the wall or ceiling.
3. Drill the mounting holes.
4. Mount the camera bracket to the wall or ceiling.
5. Connect the Ethernet cable to the camera.
6. Connect the power cable to the camera.
7. Adjust the camera angle as desired.

NVR Installation

1. Place the NVR in a suitable location.
2. Connect the Ethernet cables from the cameras to the NVR.
3. Connect the power cable to the NVR.
4. Connect the NVR to a monitor or TV.
5. Power on the NVR and monitor.

Configuration

1. Open the web browser on the monitor or TV connected to the NVR.
2. Enter the IP address of the NVR in the address bar.
3. Enter the username and password for the NVR.
4. Click on the "Configuration" tab.
5. Configure the NVR settings as desired.

Viewing Recordings

To view recordings, click on the "Playback" tab on the NVR web interface. Select the camera and time period you want to view. The recordings will start playing automatically.

Troubleshooting

If you encounter any problems during the installation or configuration process, please consult the following troubleshooting tips:
Make sure that all cables are securely connected.
Check that the NVR is powered on.
Ensure that the NVR's IP address is correctly entered in the web browser.
Reset the NVR to factory default settings.

If you are still unable to resolve the problem, please contact Hikvision technical support.

Safety Precautions

When installing and using a Hikvision wired surveillance system, please follow these safety precautions:
Do not install the cameras in areas where they may be exposed to water or moisture.
Do not overload the NVR with too many cameras.
Use only Hikvision-approved power supplies.
Do not attempt to repair the cameras or NVR yourself.

By following these instructions and safety precautions, you can ensure that your Hikvision wired surveillance system is installed and operating properly.

2024-10-28

Previous：Hikvision Surveillance Video Freeze: Causes and Troubleshooting

Next：Where to Find Recommended Surveillance Camera Enclosures in Chongqing?